Before you begin your yoga 2 disassembly, it is important to select the proper size torx screwdriver. Depending on the model of your yoga 2, you will need either a T5 or T6 screwdriver. Be careful not to strip the screws, as this will make reassembly more difficult. With the correct screwdriver in hand, you are now ready to begin taking apart your yoga 2.
Table of Contents
Why you might need to disassemble your Yoga 2
There are a few reasons why you might need to disassemble your Lenovo Yoga 2. Maybe you’re trying to clean it, or maybe you’re trying to replace a broken part. In any case, you’ll need the right screwdriver.
The type of screwdriver you’ll need is a Torx T5. This is a small, star-shaped screwdriver that’scommonly used in electronics. You can find them at most hardware stores, or online.
Once you have your screwdriver, follow these steps to disassemble your device:
1.Start by removing the back cover. There are usually 6-8 screws holding it in place.
2.Carefully lift off the cover and set it aside.
3.Remove the battery. There are usually 2 screws holding it in place.
4.Unplug the battery connector and set the battery aside.
5.Remove the screws from the main circuit board. There are usually 4-6 screws holding it in place.
6.Carefully lift off the circuit board and set it aside.
7Now you should have access to all the internal components of your device.
What tools you’ll need
In order to complete a torx disassembly of the yoga 2 manual, you will need a few tools. The most important tool you will need is a torx screwdriver. You will also need a small precision Phillips head screwdriver, and a slightly larger flathead screwdriver. Finally, it is helpful to have tweezers on hand to remove small screws and pieces.
How to remove the back panel
The back panel of the Yoga 2 can be removed with a small Phillips head screwdriver and a T5 Torx screwdriver.
How to remove the battery
To remove the battery, you will need a T6 torx screwdriver. Once you have the screwdriver, unscrew the two screws that hold the battery in place. Once the screws are removed, you can carefully slide the battery out of its compartment.
How to remove the motherboard
You will need a T3 Torx screwdriver to remove the motherboard.
How to remove the keyboard
Use a small Phillips head screwdriver to remove the two screws that hold the keyboard in place on the bottom of the laptop.
After removing the screws, gently lift the keyboard up and out of the case. If you are replacing the keyboard, you will now have access to the keyboard ribbon cable.
How to remove the screen
To remove the screen, you will need a size torx screwdriver. The screws are located on the top and bottom of the screen. Once you have removed the screws, you can carefully lift the screen off of the device.
How to reassemble your Yoga 2
This guide will show you how to reassemble your Yoga 2 after you have disassembled it. You will need a Phillips head screwdriver and a Torx T5 screwdriver.
1. Start by attaching the bottom case to the tablet. Be sure to align the tabs on the bottom case with the slots on the tablet.
2. Next, attach the rear cover to the tablet. Once again, be sure to align the tabs on the cover with the slots on the tablet.
3. Finally, replace all of the screws that you removed in Step 1. Make sure that you use the correct size screws, as using incorrect screws can damage your device.
