If you’re like me, you’ve probably found yourself in a situation where you need to turn a triangle screw but don’t have a screwdriver. Luckily, there’s a way to do it without one.
Table of Contents
Introduction
It is common to need to turn a triangle screw without a screwdriver. In many cases, it is possible to do this with a simple tool such as a nail file or a butter knife. However, there are also specialized tools available for this purpose.
The most important thing to remember when turning a triangle screw without a screwdriver is to go slowly and be careful not to strip the head of the screw. It is also important to use the correct size tool for the screws being turned.
What You’ll Need
-a hammer
-a nail
-a pair of pliers
First, take the nail and hammer it into the center of the screw head. Next, take the pliers and grip the head of the screw. Finally, twist the pliers counterclockwise until the screw comes loose.
Steps
If you find yourself in a situation where you need to turn a triangle screw but don’t have a screwdriver on hand, don’t worry—it’s possible to do so without one. All you’ll need is a coin and something to prop the coin up with. Follow the steps below and you’ll be turning that screw in no time.
1. Start by finding a coin that’s roughly the same size as the head of the screw. A dime or quarter will work perfectly.
2. Place the coin over the head of the screw, making sure that the raised edge of the coin is lined up with one of the three points of the triangle.
3. Take whatever you’re using to prop up the coin and place it under the point of the triangle opposite the one that’s lined up with the raised edge of the coin. This could be something like a pen or a piece of paper.
4. Apply pressure to the prop, pressing down on it until it’s touching both the coin and the point of the triangle. The coin should now be snug against the head of the screw.
5. Use your other hand to twist the prop clockwise or counterclockwise, depending on which way you need to turn the screw. Thecoin will start to turn along with it, and as long as there’s enough pressure being applied, shouldn’t slip out of place. Keep turning until reached your desired tightness
Tips
There are a few ways to turn a triangle screw without a screwdriver. One way is to use a flathead screwdriver. Another way is to use a pair of needle nose pliers. Another way is to use a hammer and chisel.
Warnings
Before starting any home improvement project, it is important to review any warnings provided by the manufacturer. For example, many power drills come with a warning that reads something like, “hold the drill firmly to avoid serious injury.” Be sure to read and follow all warnings before starting your project.
Things to Avoid
There are a few things you should avoid doing when trying to turn a triangle screw without a screwdriver. First, avoid using anything that can slip or slide, such as pliers or your bare hands. Second, avoid using any tool that has a pointed end, such as a knife or screwdriver, as this could damage the screw. Finally, avoid using any tool that is too large or too small for the screw, as this could also damage it.
Conclusion
There are many ways to turn a triangle screw without a screwdriver, but the most common and effective way is to use a pair of pliers.
