how to replace batterys craftsman electric screwdriver

| |

Just because your electric screwdriver’s batteries are dead, doesn’t mean it’s time to get a new one! With a little bit of know-how, you can easily replace the batteries in your electric screwdriver and get it working again. In this blog post, we’ll show you how to do just that.


It is always good to have a backup battery for your electric screwdriver, just in case the one you are using runs out of power. In this instructable, I will show you how to replace the batteries in a Craftsman electric screwdriver.

Tools and Materials

-Phillips head screwdriver
– Small flathead screwdriver
– Needle nose pliers
– Wire cutters (optional)

– 1.5V AA batteries (2 required)

Step-by-step guide

If you have a Craftsman electric screwdriver that uses batteries, over time the batteries will need to be replaced. Follow the steps below to replace the batteries in your Craftsman electric screwdriver.

1. Remove the battery cap from the bottom of the handle.

2. Insert two new AA alkaline batteries into the handle, making sure that the positive and negative ends are facing the correct direction.

3. Replace the battery cap and screw it back on tightly.

4. Test your screwdriver to make sure that it is working properly before using it again.

Tips and Tricks

Here are some tips and tricks to get the most out of your new screwdriver:

-To change the battery, unscrew the battery cap at the top of the handle and insert two AA batteries.
-To adjust the torque, turn the knob at the base of the handle. The higher the number, the more torque (or power) is applied.
-To use the built-in LED light, press the button on the side of the handle.


In conclusion, it is relatively easy to replace the batteries in a Craftsman electric screwdriver. You will need a new battery, a Phillips head screwdriver, and a flat head screwdriver. First, use the Phillips head screwdriver to remove the screws from the back of the electric screwdriver. Next, use the flat head screwdriver to pry open the battery compartment. Finally, insert the new batteries into the compartment and close it up.


how to remove battery in chicago electric 4.8 volt electric screwdriver

how to remove a macbook battery wothout a tri wing screwdriver


Leave a Comment